The Xbox 360 is one of the most current game consoles you can discover in the market with the improved new highlights to assist proprietors with deciding whether there are issues happening in the reassure and one issue is the red lights leaving you requiring an Xbox 360 red light fix. One of the highlights included the Xbox 360 are the 3 red lights which turns on when there is an issue. This issue is a mistake happening inside the comfort itself and there are a few explanations behind the blunder.

Initial Step

Open the reassure. Numerous spots will attempt to offer you exceptional apparatuses to open the case yet it is conceivable to do as such with an ordinary screwdriver and no cost. To open the support detach all the gadgets for example, hard drive and regulators and eliminate all the links. You at that point need to eliminate the face plates by holding the top and base of the plate and pulling it gradually until it pops put. Do this on the two sides. The subsequent stage is to eliminate the work spread. You can do this with a little level bladed screwdriver. By pushing down on the little dark tabs situated at the top, the center and the base of the work spread. When you have done this you can eliminate the spread by eliminating both white plates on either side. At the back of the comfort there are cuts holding the situation set up. Supplement a little screwdriver at the rear of the comfort and as you push the screwdriver in tenderly force the spread to forestall the clasps shutting once more.

Second step

Subsequent to opening the case you have to eliminate the motherboard. There are a few sinks holding it place. Eliminate these screws and tenderly eliminate the board. You at that point need to get a fix pack. This unit empowers you to supplant the x-braces that sit under the motherboard and hold the heat sink set up.

Third Step

You currently need to eliminate and supplant these x-braces. Turn the motherboard over and delicately pries them off with a screwdriver, being mindful so as not to harm the board. When you have done this you can eliminate the jolts that go through the heat sink. When you have done this get your new clasps how to upload Xbox clips and the screws and washers that accompanied them and supplant them. A few units have new compound for the heat sink. On the off chance that your unit has this adhere to the guidelines to eliminate the old compound from the heat sink by cleaning it and supplanting it with the new compound. When this is done gather the reassure backward request.